How to use the filter reactor to extend its service life?

    In order to reduce the frequency of failure of the filter reactor and prolong its service life, the following points should be noted when using and using the filtration reactor.
    1. It is strictly forbidden to disassemble with pressure when working or at the end! It is strictly forbidden to work under overpressure and over temperature!
    2. When cleaning the autoclave, special care should be taken not to allow water or other liquid to flow into the heating furnace to prevent the heating furnace wire from being blown. If it is heated by the jacketed heat transfer oil, be careful not to mix water or other liquids when adding the heat transfer oil. Check the principle of the oil-electric liquid servo universal testing machine for the heat transfer oil from time to time!
    3. During operation, if there is abnormal noise inside the forest frequency isolation sleeve of the high and low temperature test machine, the pressure should be stopped and the abnormality of the mixing system should be checked. Regularly check the amount of swing of the stirring shaft. If the amount of swing is too large, replace the bearing or sliding bushing in time!
    4. According to the voltage of the controller, connect the corresponding voltage, single-phase 220V, 3-phase 380V, the fire and zero lines of the controller should not be connected; do not work in the power transmission to prevent electric shock! In order to ensure the controller For normal operation and personal safety of the staff, please connect the grounding wire! The controller itself is not explosion-proof, so avoid the inflammable and explosive environment such as oil and gas!
    5. After the reaction temperature is affirmative, the temperature setting value is not allowed to be changed during the heating process to avoid a large overshoot of the temperature!
    6. Under the condition that the controller is powered on, even if the switch such as heating and stirring is not turned on, the output terminal of the rear panel of the controller is also charged. It is not allowed to pull any plug during operation!